How to Pair Raycon Earbuds to PC, Android, Mac or IOS

Learn how to connect Raycon earbuds to any device with these easy steps.

How to Pair Raycon Earbuds: Raycon earbuds are super flexible, designed to work with any device, and smoothly switch between them using their multipoint connection.

Connecting Raycon earbuds can be a bit different depending on your device and the specific model you have. But don’t stress – connect manually through Bluetooth. This guide will help you with help and provide some handy tips in case you run into any issues. Let’s get started!

How to Pair Raycon Earbuds
Raycon Earbuds

How to Pair Raycon Earbuds

Step 1: Begin by removing the earbuds from the capsule. They will automatically connect to each other.

Step 2: On your device, navigate to Bluetooth settings and ensure Bluetooth is enabled.

Step 3: In the list of available devices, locate and select “The Fitness Earbuds” to establish the pairing connection.


How to Reset or Factory Reset Raycon Earbuds

Step 1: Initiate the reset process by deleting the “Raycon Earbuds” entry from the Bluetooth settings on your device.

Step 2: Place the earbuds back into the charging capsule to facilitate the reset.

Step 3: While the earbuds are in the capsule, press and hold the center Reset button for approximately 5 seconds or until the LED on the capsule flashes yellow three times.

Step 4: To conclude the reset function, close the capsule.

Step 5: After the reset, follow the initial setup instructions in the manual to reconnect to your source device.


How to Set Up Multipoint:

Step 1: Commence the setup by pairing the earbuds with your primary device, such as your smartphone.

Step 2: Disconnect the earbuds from your primary device using the Bluetooth settings, prompting them to re-enter Pairing Mode.

Step 3: Proceed to pair the earbuds with your secondary device, like a laptop, using its Bluetooth settings.

Step 4: Place the earbuds back into the charging case and close the lid to power them off.

Result: Following this setup, the earbuds will be capable of seamlessly connecting to both devices when powered back on


How to Clean Raycon Earbuds

Step 1: Thoroughly clean the earbuds by removing attachments and washing them with a mild detergent and water solution. Ensure proper rinsing and drying before reattaching.

Step 2: For visible debris or earwax, utilize a soft-bristled brush or a dry cotton swab.

Note: It is crucial to avoid the use of harsh chemicals or any liquid/wet cleaning agents, as these may cause damage to the inner electronics of the earbuds.

Spread the love

Leave a Comment